- Home
- Products
- Submersible Pumps
- Xylem
- Sekamatik
- Lowara Sekamatik 100
Lowara Sekamatik 100 are Compact wastewater lifting stations with 1-2 pumps
| Specifications |
| Flow: | up to 50 m3/h |
| Head: | up to 15 m |
| Volume (total): | up to 95 l |
| Power supply: | Single and three phase 50 Hz |
| Power: | from 1,1 kW up to 2,1 kW |
| Number of pumps: | 1 or 2 |
Sekamatik 100 is a fully automatic, compact, cost effective and odor free solution for handling domestic wastewater in buildings.
It's the ideal solution whenever sanitary appliances are located at a lower level than the main gravity sewer system.
The Sekamatik 100 has an integrated check valve and is equipped with vortex hydraulics for problem free pumping and sewage. The size is suitable for residential and smaller commercial buildings.
Designed in accordance with EN 12050.
Models
Lowara Sekamatik Wastewater Lifting Stations
Sekamatik series is a range of grey / rain water or sewage lifting stations ideal for larger private or public buildings. Motor power up to 11.5 kW with capacities up to 200 m3/h and storage tanks are available in plastic with volumes from 180 up to 800 liters.
The compact design allows an installation with minimum space requirement. Sekamatik 10 E 7M is a compact behind the toilet pumping station with cutter pump. Install a toilet anywhere, typically without any major construction.
COMPACT SEWAGE DISPOSAL UNIT WITH INTEGRATED SWING CHECK VALVE.
The Sekamatik 100 is a compact sewage disposal unit suitable for pumping sewage and wastewater from toilets, hand basins, showers and rooms which are below the sewer level. Sekamatik 100 will prevent back up and flooding where there is a natural fall but the sewer is flooded or unable to drain. Sekamatik 100 is the ideal solution for new construction or renovation of old buildings.
Sekamatik 100 is used for applications in:
• basement rooms.
• sanitary facilities in cellar rooms.
• sanitary facilities in restaurants, hotels, cinemas, theatres, shopping malls, schools and hospitals.
DIN EN 12050-1: Conformity and design approved and controlled by LGA.
Pumped liquid: Clear water or drainage water, wastewater or sewage containing soft solids. Max. liquid temperature: 35°C, short term up to 60°C.
Operation: Intermittent
Construction
Flood protected single or twin pump lifting station consisting of:
Collecting tank: Odour and gas tight plastic collecting tank.
Inlets:
- Horizontal: DN 100, 180 mm height
- Horizontal: DN 100, 250 mm height
- Vertical: DN 100
- Horizontal and Vertical: DN 150
- Vertical: DN 40
Discharge: Flange DN 80. Flexible union piece DN 80/DN 100. With integrated soft ball check valve.
Air vent: DN 70 vertical. Connection for diaphragm pump: BSP 1" F. Cleaning cover with screw cap.
Pump: Pump chamber integrated in the collecting tank. Vortex impeller, spherical clearance 45 mm.
Motor: Fully submersible, pressure-tight electric motor, 1Ph or 3Ph. Thermal sensors embedded in the winding.
Insulation class F. Degree of protection IP 68. Stainless steel rotor shaft, pre lubricated bearings.
Seals: Triple lip seal combination in separate oil chamber. Oil inspection from outside.
Performance
