- Home
- Submersible Pumps
- Xylem
- Sekamatik
- Sekamatik 10
- Lowara Sekamatik 10E 15M
Compact sewage disposal unit with grinder system
The Sekamatik 10E 15M disposal unit is designed to remove wastewater from WCs, hand basins, washing machines
and showers in basements, apartments or cellars which are below the sewer backflow level and require the
installation of a lifting station. It has the advantage of a ground level direct WC connection, enabling the Sekamatik
10E 15M to be installed directly on to the back of the toilet. It incorporates a reliable stainless steel grinder system for solids.
The diameter for the discharge pipe should be 1¼" minimum, which can be easily laid at low cost with a minimum
construction work.
DIN EN 12050-1: Conformity and design approved and controlled by LGA.
Pumped liquid: Drainage water, wastewater or sewage. Max. liquid temperature: 35°C, short term up to 60°C.
Operation: Intermittent.
Specifications
Compact sewage disposal unit consisting of:
Collecting tank: Odour and gas-tight composite collection tank. Max. utility volume 11 liters. WC-inlet: DN 100
horizontal, inlet height 180 mm. Vertical inlet DN 50 on the top of the tank. Air vent DN 25 vertical. Cleaning cover
with screw cap.
Pump: Single stage centrifugal pump with horizontal discharge. Open multi-channel impeller with cutting system.
Discharge: BSP 2" M.
Motor: Single phase electric motor with thermal sensors embedded in the winding. Insulation class H. Degree of
protection IP 68.
Shaft/Bearing: Large diameter steel rotor shaft, pre-lubricated bearings.
Seals: Combination of mechanical seals (silicon carbide / silicon carbide) and lip seal with oil chamber.
Controls: Pneumatic level control with pressure switch. Electronic control box.
Overload protection. Temperature control of the winding with automatic motor restart.
Materials
| Collection tank |
Composite |
| Pump housing, motor housing, impeller |
Cast iron
GG 25/EN-GJL-250 |
| Cutting system |
Stainless steel 1.4528 |
| Rotor shaft, screws |
Stainless steel |
| Seal kit |
NBR |
Technical Data
| Motor input |
1,5 kW1 |
| Motor output P |
1,1 kW2 |
| Voltage |
230 V/1 Ph, 50 Hz |
| Speed |
2900 rpm |
| Nominal current |
7,0 A |
| Cable |
H 07RN–F 4G1,5 |
| Weight |
32 kg |
| Discharge |
BSP 2" M |
Equipment supplied
Tank with pump, pneumatic electronic control box, 2 m of cable and plug.
Performance
Installation
Dimensions.
(all dimensions are in mm.)
- Inlet DN 100
- WC-direct connection
- Connection for discharge pipe
BSP 2'' M
- Cable inlet
- Cleaning cover
- Connection for pneumatic
level control
- Inlet DN50
- Air vent cap with PVC tube
- Pump cover
- Knurled screws
- Tank fixing point
